Chuck Package Deal -  
This superb value package deal includes everything an aspiring woodturner needs.
W836 Geared Scroll chuck
W836JB Small Jaw Set
W836DC Chuck Drive Centre
W836ID Insert for 3/4" x 16tpi Threadsize
W836ALU Aluminium Storage Case

W836; For serious woodturners a geared scroll chuck is the only choice. This high precision 4 jaw chuck uses just one T-bar to adjust the jaws which means mounting a workpiece is very simple and you will not run out of hands.
The basic chuck has a direct thread size of M33 x 3.5, the package also includes an insert for using the chuck with 3/4" x 16tpi thread lathes. For all other thread sizes an additional insert must be purchased.
The chuck is supplied with an Index plate marked with 24 positions.

W836JB; These small jaws allow smaller pieces to held than the standard jaws.

Expands from 22mm to 59mm
Contracts from 43mm to 6mm

W836DC; Turn spindles without removing your chuck from the lathe using this four prong drive centre. The centre point insert is removable and a blank pin for long hole boring is also supplied.

W836ALU; Smart aluminium storage case with foam lining and pockets to protect all you accessories.
Other optional jaw sets are also available;
W836JA Large jaw set expands from 98mm to 135mm and contracts from 119mm to 82mm.
W836JC Long Nose jaw set expands form 18mm to 55mm and contracts from 40mm to 3mm.
W836JD Bowl reversing jaws are used for re-chucking bowls, once the inside has already been formed. It can be used to remove chucking marks form the base of a piece.